Cressi comanch spear
2 Attachment(s)
I bought a spear for my new gun from cressi ,spear fit the comanche gun ,as in pictures the shark fin have been welded laser fillet weld but not all around ,only both side ,slavimar spear weld all around to prevent the internal corrosion of weld bead ,is their any way to prevent that? ,usually the fin will be break sooner
its like a control the life cycle so you have to buy again (solution rather than weld) |
Re: Cressi comanch spear
If you use them for spearfishing, they'll bend before anything else happens. Don't worry and get them wet.
|
Re: Cressi comanch spear
Spray the tabs with WD40 after each dive if you are worried about it. Wash the spears first to get any saltwater off. WD40 drives any trapped water out.
|
Re: Cressi comanch spear
WD40 will swollen the bands. I would just rinse and worry about shooting fish.
|
Re: Cressi comanch spear
I have tried the W40 and silicon spray , both work fine hope it will shoot many fish in this season
|
Re: Cressi comanch spear
Quote:
Mikel |
All times are GMT -5. The time now is 09:10 PM. |
The World's Largest Spearfishing Diving Social Media Forum
Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2002 - 2014 Spearboard.com